How To Repair Sony Rm-tp504

32

Additional data

Troubleshooting

If y'all experience any of the following difficulties while
using the commander, use this troubleshooting guide to
aid you remedy the problem. Should any problem
persist, consult your nearest Sony dealer.

Operation tin non be done with the commander.

/ Check that the receiver and components are

connected correctly.

/ The commander and receiver are also far apart.
/ Make sure that there are no objects between the

commander and receiver.

/ Brand sure that the receiver's power is turned on.
/ The commander'due south transmitter/receiver section is

not pointed at the receiver.

/ The commander's batteries are wearied. Replace

with new alkaline batteries (see page 7).

/ There is an invertor organisation florescent light virtually the

commander or receiver. Please place away from
the florescent calorie-free.

/ Make sure yous have selected the correct role

on the remote.

/ When you operate a programmed non-Sony

component, the remote may not function properly
depending on the make and model of the
component.

The receiver'due south functions and modes practice not
correlate with the displays on the commander.

/ Initial advice setup has not been done.

Use after first carrying out initial communication
setup (see page half-dozen).

/ The commander was not pointed at the receiver

when information technology was turned ON. Touch RELOAD, and
download component information (see folio viii).

/ Select the correct function using the commander.

LCD does not appear.

/ The LCD is not turned on. Bear upon the touch console.
/ Contrast is too light or too dark.

Use the CONTRAST control to adjust the contrast
of the LCD (come across page half-dozen).

When a CD role player, tape deck, or MD deck is
continued to the receiver via CONTROL A1/A1
jacks, Auto Part does not work properly.

/ Reprogram the remote (see page 29).

The SOUND FIELD function does not piece of work.

/ If the receiver has v.1 INPUT jacks, the Sound

FIELD part becomes inoperable when 5.1CH is
selected.

Commands of components made by
manufacturers other than Sony do not function.

/ When registering components made past certain

manufacturers, some commands may not function
even though they are displayed.

"5.1INPUT" cannot be selected from the part
screen even though the receiver has the
5.1 INPUT jacks.

/ A communication fault has occurred. Point the

remote towards the receiver and select "v.1INPUT"
from the part screen again.

The remote and the receiver cannot
communicate.

/ If the receiver'southward COMMAND MODE and the

remote's COMMAND MODE do not match,
transmission is not possible between the remote
and the receiver.

Source: https://www.manualsdir.com/manuals/442996/sony-rm-tp504.html?page=32

Posted by: forbescousitony.blogspot.com

Share this post