How To Repair A Single Handle Delta Kitchen Faucet

How to Replace a Kitchen Faucet

Kitchen faucets are probably one of the most used fixtures in homes. Many times a day the water is turned on and off, leading to quite a fleck of wear and tear on this hardworking fixture. If your faucet has seen better days, or is out of style, you can supervene upon it with a shiny new version using but a few tools. Exchanging your former kitchen faucet with a new one can transform the expect and functionality of your kitchen in just a couple of hours.

Tools you'll Need

Have all the necessary tools for this DIY project lined up before you first to save yourself time and frustration.

New Faucet
Channel locking pliers
Bowl wrench
Plumber'south Putty
Adaptable Wrench
Flexible supply lines
Tape Measure

Before Starting

Plough off the hot and common cold h2o close-off valves. they're usually located in the cabinet that's under the sink. So open up upwards the faucet to relieve pressure.

Removing the Former Faucet

Step 1: Using an adjustable wrench and a pair of channel locking pliers, disconnect both the water lines from the faucet. If the supply lines are old, or the gaskets are worn out, yous may desire to replace them with flexible supply lines.
Step Ii: Using a socket wrench or basin wrench remove the nut that is holding the faucet tailpiece assembly in identify. Sometimes it'due south difficult to loosen old faucet nuts, in that case endeavor soaking the threads with penetrating oil and attempt over again.
Step Three: If your sink has a line that connects the hose to the faucet y'all can disconnect this.
Pace Four: Pull the old faucet out and make clean the sink's surface making sure to remove any rust or caked on droppings.

Installing the New Faucet

Step I: Using the measuring record, mensurate the distance, from heart to eye, of the exterior holes of your sink. This is to make sure the new faucet will fit. Since all faucets are slightly dissimilar, read any installation instructions that come with your new faucet. Follow all manufacturer'due south pre-assembly instructions and place the optional flange over the faucet opening.
Step 2: Seal the new faucet. If you're using a gasket, place the gasket on the lip of the plate and thread the hoses through. If using plumber's putty, apply it effectually the base of operations of the faucet and set the faucet in place.
Step 3: Nether the sink yous can at present thread on the flange and nut using a socket or basin wrench.
Step Iv: If you're using pull-out faucets, a weight needs to be added that will retract the pull-out spray.
Pace V: Now it'southward time to attach the supply lines to the faucet and so to the shut-off valves. Common cold h2o connects on the right and hot water on the left.
Step Six: Plow on the h2o and check for leaking. If you lot find whatsoever leaks yous'll need to tighten the connections on the water supply line.